【Notes】
1. Please follow the instructions below to install and use, please do not DIY or connect third-party accessories. Failure or damage caused by failure to follow instructions is not covered by the Insta360 warranty or exchange service.
2. This accessory is not recommended for use on public roads. Please ensure that the surrounding road environment is safe before use.
3. This car dual suction cup/triple suction cup holder can only be used with Insta360 high-strength invisible selfie stick, please do not use it with other selfie sticks.
4. Please use this product in an ambient temperature environment of 0-40°C (32-104°F).
5. Please try to install the suction cup on the same horizontal plane (or the plane with the smallest slope). If it cannot be installed on the same horizontal plane, the suction cups on both sides of the horizontal support rod must be attached to the same plane, and the suction cups on the extended support rod must be installed on another plane.
6. Before installing the suction cup, make sure the surface is smooth and clean.
7. When installing the suction cup, make sure that the suction cup is completely attached to the flat surface. If the suction cup does not fit properly, loosen the knob and adjust the suction cup angle; reinstall the suction cup and tighten the knob.
8. The white area on the suction rod is the indicator line. After installing the suction cup, please pull out the suction rod and release it. Observe whether the indicator line is exposed. If the indicator line is exposed, you need to hold and pull the suction rod repeatedly to ensure that the suction cup is firmly adhered. If the indicator line returns to the outside of the pump body for a short time (the indicator line outside can be seen), there is an air leak and the suction cup needs to be reinstalled.
9. After installing the complete bracket, make sure all the knobs on the bracket are tightened. Do not use the suction cup holder if the knobs cannot be tightened or if the suction cup adapter, telescoping support rod or Selfie connection remains unlocked after all knobs are tightened.
10. If you need to stop and take a rest during use, please check the suction cup for accidental air leakage (you can see the indicator line outside). If the suction cup has leaked, please reinstall the suction cup to prevent the bracket from falling and damaging the camera.
11. When removing the suction cup, use your fingers to pry the edge of the suction cup to create a gap between the suction cup and the flat surface, and you can easily remove the suction cup.
12. After use, if the surface of the suction cup is dirty, it needs to be wiped clean in time to ensure that the suction cup can maintain sufficient adsorption power when used next time.
13. When assembling this vehicle-mounted three-suction cup bracket, do not use it in overly rough off-road conditions (including but not limited to large rocks, very bumpy, steep mountain roads), and do not drive at a speed exceeding 100 km/h (62 mph). ).
14. When assembling this car dual suction cup holder, please do not use it on roads other than flat asphalt roads, and do not drive the vehicle at a speed exceeding 80 km/h (50 mph).
15. The suction cup of this product adopts a modular design. When using a single suction cup, it can only be connected to the Insta360 high-strength invisible selfie stick. Keep it in the retracted position and do not unfold the selfie stick.
16. When driving, when the selfie stick is fully extended, the dynamic load of the suction cup bracket is 300g. Do not add heavy objects.
17. Do not install this accessory on the car for an extended period of time. When not shooting for a long time, please remove and save the accessories to maintain the quality of use.
